pos teleop

examples/openarms/setup_can.sh

@@ -0,0 +1,73 @@
+#!/bin/bash
+# Setup all OpenArms CAN interfaces with CAN FD
+
+set -e
+
+echo "=========================================="
+echo "OpenArms CAN FD Interface Setup"
+echo "=========================================="
+echo ""
+echo "Mode: CAN FD"
+echo "  - Nominal bitrate: 1 Mbps"
+echo "  - Data bitrate: 5 Mbps"
+echo ""
+echo "Configuring interfaces can0, can1, can2, can3..."
+echo ""
+
+# Configure each CAN interface with CAN FD
+for i in 0 1 2 3; do
+    interface="can$i"
+    
+    # Check if interface exists
+    if ! ip link show "$interface" &> /dev/null; then
+        echo "⚠ $interface: Not found, skipping"
+        continue
+    fi
+    
+    # Bring down interface
+    sudo ip link set "$interface" down 2>/dev/null
+    
+    # Configure CAN FD mode
+    sudo ip link set "$interface" type can \
+        bitrate 1000000 \
+        dbitrate 5000000 \
+        fd on
+    
+    # Bring up interface
+    sudo ip link set "$interface" up
+    
+    # Verify configuration
+    if ip link show "$interface" | grep -q "UP"; then
+        echo "✓ $interface: Configured and UP"
+    else
+        echo "✗ $interface: Failed to bring UP"
+    fi
+done
+
+echo ""
+echo "=========================================="
+echo "Verification"
+echo "=========================================="
+echo ""
+
+# Show detailed status for each interface
+for i in 0 1 2 3; do
+    interface="can$i"
+    if ip link show "$interface" &> /dev/null; then
+        echo "$interface:"
+        # Show key parameters
+        ip -d link show "$interface" | grep -E "can|state|bitrate|dbitrate" | head -3
+        echo ""
+    fi
+done
+
+echo "=========================================="
+echo "Setup Complete!"
+echo "=========================================="
+echo ""
+echo "All interfaces configured for CAN FD mode"
+echo ""
+echo "Next steps:"
+echo "  1. Test motors: python debug_can_communication.py"
+echo "  2. Run teleoperation: python examples/openarms/teleop.py"
+echo ""